窗臺施工工藝節選.doc

一、窗臺新的施工工藝
窗臺滲漏的原因：
（1） 窗臺頂面外側部分坡度不夠，出現倒泛水；
（2） 窗臺抹灰不平，沒有向外的坡度；
（3） 窗框與抹灰面接觸處，填塞不實、封閉不嚴或密封膠開裂。
新的施工措施：
1、 在貼外墻面磚時，按照窗臺的控制標高留置窗臺面，并將窗臺頂面面磚按30~40的坡度粘貼。
2、 窗洞口抹灰時，在窗框處，沿窗臺頂面面磚里邊沿，用水泥砂漿做一高20~30mm的臺階，并且窗框下面的抹灰向外略微傾斜（框是彈性安裝，四周要留5~8mm的空隙，抹灰面略微放坡，不影響窗框安裝）。
3、 在窗框安裝好后，巖棉或巴提瑪槍式聚氨酯泡沫填縫劑填塞密實，在窗框兩側縫隙用硅酮密封膠密封即可。
通過采用上述方法，消除了窗臺倒泛水現象，解決了窗臺滲漏的問題，效果良好。

二、防止地面磚空鼓的措施
1、 基層必須認真清掃干凈，并灑水充分濕潤，濕潤時間一般為24h，且無積水現象，以保證墊層與基層結合良好。
First, new construction technology in window
Window leakage of reasons:
(1) the lateral part of the slope of the top window is not enough, there inverted pan of water;
(2) uneven plaster window, there is no outward slope;
(3) The window frames and plaster surface contact, filling false, strictly closed or sealed plastic cracking.
Construction of new measures:
1, when facing tiles in the paste, according to the control window sill surface elevation of lien, and the top tile window by 30 to 40 of the slope paste.
2, when the window hole plaster, in the window frames Department, along the windowsill inside the top edge of tile, cement mortar to make a high-level 20 ~ 30mm, and the window frame plaster below tilt slightly outward (box is a flexible installation, to stay around 5 ~ 8mm gap, floated slightly sloping, does not affect the window frame installation).
3, the window frames installed, rock wool or polyurethane foam sealant gun-type Ba Tima dense packing in window frames on both sides of gaps can be sealed with silicone sealant.
By using this method to eliminate the phenomenon of window flashing back to solve the window leakage problem, good results.

Second, measures to prevent land Facing Tiles
1, grass-roots must be carefully cleaned, and the full wet sprinkler, wet time usually 24h, and no water phenomenon in order to ensure a good combination of cushion and grass-roots.
 

前往下載