壁柜、吊柜安裝技術交底.doc
進入下載頁
交底內容：
壁柜、吊柜安裝
本技術交底適用于一般建筑和賓館建筑壁柜、吊柜安裝工程。
1．材料要求
（1）壁柜、吊柜木制品由工廠加工成品或半成品，木材含水率不得超過12%。加工的框和扇進場時應對型號、質量進行核查，需有產品合格證。
（2）其他材料：防腐劑、插銷、木螺絲、拉手、鎖、碰珠、合頁按設計要求的品種、規格備齊。
2．主要機具
（1）電焊機、手電鉆。
（2）大刨、二刨、小刨、裁口刨、木鋸、斧子、扁鏟、木鉆、絲錐、螺絲刀、鋼水平、鑿子、鋼銼、鋼尺。
3．作業條件
（1）結構工程和有關壁柜、吊柜的構造連體已具備安裝壁柜和吊柜的條件，室內已有標高水平線。
（2）壁柜框、扇進場后及時進行加工并靠墻、貼地、頂面應涂刷防腐涂料，其他各面應涂刷底油一道，然后應分類碼放平整，底層墊平，保持通風，一般不應露天存放。
（3）壁柜、吊柜的框和扇，在安裝前應檢查有無竄角、翹扭、彎曲、劈裂，如有以上缺陷，應修理合格后，再行拼裝。吊柜鋼骨架應檢查規格，有變形
Cards on the table contents:
Cabinets, hanging cabinet installation
The technical disclosure for general construction and hotel building cabinets, hanging cabinet installation.
1. Material requirements
(1) cabinets, wood hanging cabinet, or semi-finished products from the factory, wood moisture content should not exceed 12%. Processing comes into the box and fan response model, the quality of verification, the need for product certification.
(2) Other materials: preservatives, bolt, wood screws, handles, locks, touch beads, hinge according to design requirements of the varieties, specifications get ready.
2. Major equipment
(1) welding machines, hand drills.
(2) a large plane, two plane, small plane, cut mouth planing, wood saw, axes, flat shovel, wood drill, tap, screwdriver, steel level, chisel, steel file, steel rule.
3. Operating conditions
(1) structural engineering and the cabinet, hanging cabinet piece has been the construction of installation of cabinets and hanging cabinet with the condition, interior has elevation level.
(2) cabinet box fan after the timely processing of admission and the wall, paste, the top anti-corrosion coating to be brush, brush the other side should be a base oil, and should be classified laying is flat, the bottom level up, to keep Ventilation should not generally open storage.
(3) cabinet, hanging cabinet box and the fan, before the installation check for channeling angle, Alice twisting, bending, splitting, if these defects should be repaired after passing the re-assembly. Should check the specifications of steel skeleton hanging cabinet, there is a deformation