室內自動噴水滅火系統安裝技術交底-北京建工集團.doc

  1  范圍：本工藝標準適用于建筑物、構筑物設置的自動噴水滅火系統工程的安裝。
    2  施工準備。
    2.1  接到施工任務后，認真熟悉圖紙及施工現場，發現有影響施工的設計問題時，及時與有關人員研究，辦理洽商手續。按照工程特點確定施工方法，配備相應的勞動力、設備、材料、機具等。同時配備配套的生活、生產臨時設施。
    2.2  設備、材料：
    2.2.1  自動噴水滅火系統主要設備材料的選用應符合6條“消防工程安裝的通知”的有關內容。
    2.2.2  主要設備：噴淋泵，水泵結合器，報警閥及組件，信號控制閥，水流指示器，噴灑頭，氣壓給水裝置，穩壓泵等。其中噴灑頭，報警閥，壓力開關，水流指示器等主要系統組件應有國家消防產品質量監督檢驗中心檢測報告。
    2.2.3  一般常用材料：管材及連接件，型鋼，焊條，氧氣，乙炔，厚漆，麻，聚四氟乙烯帶，膨脹螺栓，密封墊，螺栓，螺母，機油，防腐漆，稀料，小線，鉛絲，電池等。
    2.3  主要機具，套絲機，砂輪鋸，臺鉆，電錘，手砂輪
1 Scope: This technique is applicable to buildings and structures set up the installation of sprinkler systems engineering.
    2 construction preparation.
    2.1 After receiving the construction task, seriously familiar drawings and construction site, found that the design issues affecting construction, timely and relevant personnel research, handling negotiation procedures. Determined in accordance with the characteristics of the project construction method, with the corresponding labor, equipment, materials, equipment, etc.. Also equipped with supporting life, the temporary production facilities.
    2.2 Equipment and materials:
    2.2.1 fire sprinkler system is mainly the selection of equipment and materials shall comply with 6 "fire engineering installation notice" of the content.
    2.2.2 Main equipment: spray pump, pump combiners, alarm valves and components, signal control valves, flow indicators, spray head, pressure water supply equipment, pumps and other regulators. One sprinkler head, alarm valves, pressure switches, flow indicators and other major system components should be the national product quality supervision and inspection center fire test report.
    2.2.3 commonly used materials: pipes and fittings, steel, welding rods, oxygen, acetylene, Hou Qi, hemp, Teflon tape, expansion bolts, gaskets, bolts, nuts, oil, anti-corrosion paint, thinner, smaller line , wire, batteries.
    2.3 The main equipment, threading machine, wheel saws, bench drill, electric hammer, hand wheel
 

前往下載